Dot Hill Systems SANnet II 200 Manual de Serviço descarregar pdf (Página 179)

G-1

APPENDIX

Configuring a Linux Server

This appendix provides access information and LUN setup information needed when

you connect a FC, SATA, or SATA SE array to a server running the Linux operating

system. For a list of supported adapters, refer to the SANnet II 200 FC, SATA, and

SATA SE Array Release Notes.

This information supplements the configuration steps presented in this manual and

covers the following topics:

■ “Setting Up the Serial Port Connection” on page G-1

■ “Accessing the Firmware Application From a Linux Server” on page G-3

■ “Checking the Adapter BIOS” on page G-4

■ “Multiple LUN Linux Configuration” on page G-5

■ “Making an ext3 File System for Linux” on page G-5

■ “Creating a File System” on page G-6

■ “Creating a Mount Point and Mounting the File System Manually” on page G-7

■ “Mounting the File System Automatically” on page G-7

■ “Determining the Worldwide Name for Linux Hosts” on page G-8

G.1 Setting Up the Serial Port Connection

The RAID controller can be configured by means of a host system running a VT100

terminal emulation program or running a terminal emulation program such as

Minicom.

Note – You can also monitor and configure a RAID array over an IP network with the

SANscape program after you assign an IP address to the array. For details, see “Setting

Up Out-of-Band Management Over Ethernet” on page 4-28 and refer to the SANscape

User’s Guide.

To access the controller firmware through the serial port, perform the following steps:

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 209 210

Sem comentários

Dot Hill Systems SANnet II 200 Manual de Serviço Página 179